Of course, this is very noticeable and easy to identify since when connects Sparks will they mark at the place where missing paint. Small lattice or mesh that is on the internal face of any oven door of microwave, allows that the light between and avoids radiation out of the cavity; i.e. works as catch waves. The incidence of light is no problem, since their wavelength is very small; more like microwaves is higher, these must be retained in any way; Why is incorporated the traps metallic waves precautions during the service and use of the appliance for safety of the computer and the user, is very important to point out the following: 1. never bypass or delete the IsLocked located next door, because these safety devices prevent the computer from operating when the compartment is open 2. Once you have uncovered equipment to test its performance, stay away from the magnetron at least 30 cm. remember that although it is shielded, it can have some sort of leak.
3 Recommend to clients that they never uncover the unit to review its internal parts. Only qualified personnel may perform repair. 4 You will have noticed that the appliance has one or two thermal sensors; never delete them since they are what prevent overheating of magnetron and their subsequent destruction, which is very important for the high cost of that device that it tends to be almost like a new microwave from low quality or cost. The rigor is located to one side of the magnetron, and other normally at the opposite end. With them is detected temperature level which is usually 150 or 170 degrees Celsius.
These sensors are actually switches that open when they detected high temperatures; since they are in series with the input line, in time to reach its nominal value opens to prevent that all equipment is energized; it resumes its normal operation, only until they lower their temperature. On the other hand, remember that the magnetron working with loads ranging from 2,500 to 3,000 volts approximately; Therefore, never reach around the main transformer when it is in operation, do not attempt to try it or with a driver or with a common tester which we use Typically this uses a small circuit with resistances that can be found easily on the internet or by visiting my website-www.sime.com.uy. Also remember that once disconnected from the network even keeps intention of a capacitor that must be downloaded before maneuvering with the magnetron. It can also use some electronic device very easy to manufacture for the detection of leaks in the oven that you can search on the internet or as previously mentioned I already find it before and this in my website as I always say it is the way more easy to help technicians and find everything in one place and free without having to register or pay for help.